Knob & Bushing Puller

Instructions

For Knob Removal - Simply slip the knob pulling end under the knob and tighten the wing nut, the knob will slip straight off. The rubber base will not mark a guitar's finish, just be cautious of guitars with carved tops that the base does not put too much pressure on one small area.

For Bush Removal - If the guitar has been finished after the bushes are installed, as is the case with most Gibsons it is important to cut through the finish around the bush. This will stop the bush taking the finish with it and reduce the risk of chips. Screw in the appropriate sized threaded anchor into the bush and then attach this to the end of the knob puller. Tighten the wing nut and the bush will slide straight out.