Fret Hammer - Brass & Plastic Heads

In stock
SKU
TL-014-001
$113.90
Fret Work Hammer The perfect size and weight hammer for installing frets - Brass and plastic tips reduce denting of frets - 250mm long (9.8") - 70mm head (2.76") - 25.4mm (1.0") Dia. head - 230g weight WARNING-PROTECT YOUR EYES-WEAR SAFETY GOGGLES Any soft face hammer or mallet may chip if struck against rough or shaped edged object, possibly resulting in bodily injury.
Related Products
We found other products you might like!
To hammer in frets start by hitting the fret lightly, just so the bottom of the tang goes into the slot and the fret stands upright. Then hit harder, starting at one end of the fret and working towards the other.

There is no set rule of how many times to hit the fret and it will depend on the slot, fretwire, timber in the fingerboard and radius. Normally 2-4 passes of about 6 hits is enough to get the get the fret fully seated without damaging it too much.

Try not to hit too hard in one place as it can dent or bend the fret. It takes a bit of getting used to hitting with the right amount of force but once you have mastered this the frets will go in evenly.
More Information
Material Brass, Plastic, Steel
Tool Type Hammer

About Us

Luthiers tools, guitar parts, fretwire, timbers and more.

For instrument makers and repairers.

We stock Australia’s largest range of Luthier Supplies ready for next day shipping.

More About Us

Ordering + Shipping

Information

Contact

Email Us

0409 635 288
Mon-Thu 1pm-3pm (Qld time)

Australian Luthier Supplies
PO Box 8452
Gold Coast MC
QLD 9726 Australia

© 2019 Australian Luthier Supplies. All Rights Reserved.
Payment Methods